What to do if my EdgeStar AP14009COM-1 continues to operate after water tray is full?
If your EdgeStar Air Conditioner continues to operate after the water tray is full, or if water full protection occurs frequently, check the water level switch connections. If the switch is defective, replace it. Also, ensure the water level switch is operating correctly and not stuck or being interfered with.
What to do if my EdgeStar AP14009COM-1 is not cooling at all?
First, ensure the unit is set to cooling mode and that you've lowered the desired temperature. The compressor might take up to 3 minutes to engage, possibly longer if it's very warm. Check that the room temperature is below 90°F. Also, make sure the exhaust port isn't blocked. Finally, examine the filters; if they're dusty or blocked, clean them.
How to fix EdgeStar AP14009COM-1 that is not functioning at all?
If your EdgeStar air conditioner isn't working, start by ensuring it's properly plugged in. Check the LCDI power cord and press the Reset button if it's tripped. Try moving the unit to another outlet and inspect your circuit breaker, consulting the rating label on the back of the unit for amperage. If the water reservoir is full, drain the unit and restart it. If no indicator lights illuminate, it may indicate a disconnected control panel, and you should contact customer service.
Why does my EdgeStar Air Conditioner blow cold air but not lower the room temperature?
Several factors can cause this issue. First, confirm that the unit is properly vented. The room may be too large for the unit's capacity; consider minimizing the area, using multiple units, or upgrading to a larger unit. Ensure all windows and doors are closed, and eliminate or reduce heat sources in the room. Check that the room is adequately insulated and that the ambient temperature is below 90°F. Minimize direct sunlight by closing curtains or blinds. Clean or replace the filter if it's dirty, vacuum the condenser coils, and remove any obstructions from the air intake or exhaust ports.
What to do if my EdgeStar AP14009COM-1 is making a loud noise?
Ensure the unit is placed on a level surface. Check for any foreign objects that may have jammed the fan and remove them. If the floor beneath the unit is uneven, relocate it to a level surface.
What to do if my EdgeStar Air Conditioner remote control does not work?
If your remote isn't working, begin by installing new batteries, ensuring they are correctly oriented. If that doesn't resolve the issue, the remote control may be defective, and you should contact customer service.
Why is my EdgeStar AP14009COM-1 Air Conditioner leaking?
Check to ensure the drain plug is securely attached. If the leaking persists, the base pan may be cracked, and you should contact customer service.
What to do if my EdgeStar AP14009COM-1 Air Conditioner runs for a while then trips the power cord?
The air conditioner might be plugged into an outlet that doesn't provide enough current. If the unit functions correctly in a different room or circuit, consult an electrician.
Why is my EdgeStar AP14009COM-1 Air Conditioner making a continuous metallic knocking sound?
If your unit was shipped on its side, turn it off and let it sit on a level surface for at least 24 hours before restarting it. If the sound persists, the compressor may be damaged, and you should contact customer service.
What does it mean when the front control panel lights blink red on my EdgeStar AP14009COM-1 Air Conditioner?
If the front control panel lights are blinking red, it indicates that the water reservoir is full. You should drain the unit.
Safety guidelines related to electrical components and power usage.
General safety rules for operating the unit, including child supervision.
Instructions for testing the Leakage-Current Detection and Interruption safety plug.
Welcome message, manual purpose, and space for recording unit details.
Identifies key components visible on the front and back of the unit.
Step-by-step guide for installing the activated carbon filter with the pre-filter.
Lists window kit components and initial preparation steps.
Identifies the water line for the continuous drain option.
Steps to insert and secure the grated adapters into the window kit plate.
Steps to install the window plates and secure them in the window opening.
Instructions for attaching the exhaust hose connectors to the hose ends.
Steps to connect the duct connectors to the unit and the grated adapter.
Important considerations for using the exhaust hose effectively and avoiding issues.
How to drain water directly from the unit using a hose.
Setup for continuous drainage using the internal pump and water line.
Description of remote control buttons and their operational functions.
Explanation of the elements shown on the remote control's LCD screen.
Instructions for inserting batteries into the remote control.
Explains the various indicators displayed on the remote control's LCD.
How to use the remote for basic functions and cooling mode.
Instructions for operating the unit in dehumidifying, fan-only, and automatic modes.
How to change fan speed settings in cooling and fan-only modes.
Step-by-step guide to setting the internal clock on the unit.
How to set the timer for automatic turn-on or turn-off.
Explains the meaning of the different colored lights on the front panel.
Details the emergency power switch and lamp off features.
Tips for efficient operation and maximizing performance.
Instructions for cleaning the air conditioner unit and its pre-filter.
Steps to prepare the unit for long-term storage.
A guide to diagnose and resolve common problems with the air conditioner.
Lists key technical specifications of the portable air conditioner.
Explanation of the Seasonally Adjusted Cooling Capacity (SACC) rating.
Details what is covered, not covered, and exceptions in the warranty.
Instructions on how to contact EdgeStar for warranty claims and support.
General| Power Supply | 115 V/60 Hz |
|---|---|
| Modes | Cool, Fan, Dehumidify |
| Fan Speeds | 3 |
| Digital Display | Yes |
| Remote Control | Yes |
| Programmable Timer | Yes |
| Self-Evaporative System | Yes |
| Operating Voltage | 115 V |
| Operating Frequency | 60 Hz |
| Refrigerant | R410A |
| Installation Type | Window |
| Timer | 24-hour |
| Sleep Mode | Yes |
| Auto Restart | Yes |
| Cooling Capacity | 14000 BTU |
| Coverage Area | 700 sq ft |
| Window Kit | Yes |
| Warranty | 1 year |
To Next Page
