EdgeStar AP14009COM-1 - Fan Speed and Clock Settings; Adjusting Fan Speed; Setting the Unit Clock

16
Fan Speed
The Fan Speed button is used to change the fan speed while in Cooling and Fan Only
modes.
Press the Fan Speed button to select the fan speed. Automatic , High , Medium ,
or Low speed can be selected,
Clock
The Clock button is used to set the Clock.
To set the Clock:
1. Press and hold the Clock button until the Clock indicator starts blinking.
2. Set the time by using the Up and Down buttons. Holding down the buttons
longer than 1 second will change the time in fast mode. The clock is a 24-hour clock so if it is
6:00 pm you would set the clock time to 18:00.
3. To save your settings press and hold the Clock button until the Clock indicator stops
blinking.
12-Hour
24-Hour
1:00 pm
13:00
2:00 pm
14:00
3:00 pm
15:00
4:00 pm
16:00
5:00 pm
17:00
6:00 pm
18:00
7:00 pm
19:00
8:00 pm
20:00
9:00 pm
21:00
10:00 pm
22:00
11:00 pm
23:00
12:00 am
00:00
Note: You will not be able to change the fan speed if the unit is in Automatic or Dehumidify mode.
Tip: Use the chart below to set the Clock.