EdgeStar CWB2886FD - Page 17

- 17 -
3.
DISASSEMB
LY
5. The control board is like below. (figure 44)
Figure 44
6. Disassemble the display board. (figure 45)
Figure 45
7. The display board is like below. (figure 46)
Figure 46
(Models：CWR361FD)
1、 T
ake down both doors.
2、 Remove five screws from the top panel.
(figure 47)
Figure 47
3、 Pull out the top panel。(figure 48)
Figure 48
4、Remove all the connector from the PCB board.(figure 49)
Figure 49
5、Remove four screws and take out the PCB board.(figure 50)
Figure 50
6、 The control board is like below. (figure 51)
Figure 51
7、Remove 6 screws from the PCB board and take it
out .(figure 52)
Figure 52
8. The display board is like below. (figure 53)
Figure 53