Reassembly of the coin trap/lint trap component of the EdgeStar Washer Dryers
If the end piece of the coin trap component on EdgeStar combination washer dryers is
fully unscrewed, the component can come completely apart. Here is how you re-assemble
it
t.
Start with the pieces shown in the order below.
2. Put the rubber gasket onto the end of the Ion _iece, as show below.
.
Put the white piece
as shown below.
4, Lightly screw the remaining piece onto the assembly, as shown below.
5. Now the component is reassembled and can be reinserted (and then tightened)
into the combo.
To Next Page
Loading...