To Next PageTo Next PageHow to enter test mode on my EdgeStar Washer/Dryer?
To enter test mode on your EdgeStar Washer/Dryer, ensure the machine is empty and drained of water. Shut down the machine using the 'On/Off' button. Disconnect the plug from the power supply, wait 10 seconds, and reconnect it. Then, press the buttons in the following sequence: Temp – Soil – Temp – Soil.
General| Capacity (Wash) | 1.5 cu. ft. |
|---|---|
| Capacity (Dry) | 1.5 cu. ft. |
| Capacity | 1.5 cu. ft. |
| Control Type | Electronic |
| Dimensions | 33.5" H x 23.5" W x 22" D |
| Weight | 150 lbs |
| Color | White |
| Voltage | 120V |
| Width | 23.5 inches |
| Height | 33.5 inches |
| Wash Cycles | 8 |
| Spin Speeds | 3 |
| Type | Washer/Dryer Combo |
| Drying Method | Ventless |
| Depth | 22 inches |
Troubleshooting steps for drain errors, including checking pump filter, wires, and pump.
Step-by-step guide for checking and replacing the Printed Circuit Boards (PCBs).
