EdgeStar CWD1550W - No Water or Water Fill Time Too Slow (E10)

19
No Water or Water Fill Time Too Slow (E10)
No Water or Water Fill Time Too Slow (E10)
Drain Hose Installation Issue?
Check water supply valve to ensure fully open
Check the water pressure
Check the drain hose
Check the inlet filter for blockage
Check the wire connection.
Check wires for open circuit.
Check the inlet valve. Replace if failure.
Replace the PCB's
Drain height should be
between 24” and 40” from
the bottom of the washing machine
The water pressure should measure between
0.05MPa to 1MPa (7.25 PSI to 145 PSI)
Pull out the inlet filter(s) with needle nose pliers and
wash under warm water to remove any debris.
Replace the harness
if open circuit detected.
The resistance on coil
should be between 4-5KΩ.