EdgeStar CWD1550W - Troubleshooting; Test Mode

6
Freeze Prevention and Help:
If your washing machine is located in the room where it can get frozen easily, please drain the
remaining water inside drain pipe and inlet pipe thoroughly. Remove the remaining water in the inlet
pipe and drain pump.
If unit experiences a freeze when water has not been preventatively drained, please follow the below
instructions.
1. Disconnect the power supply for the washing machine.
2. Wash the supply valve / supply tap with warm water to loosen inlet pipe.
3. Remove supply lines / inlet pipes and immerse in warm water to thaw.
4. Pour warm water into washing drum and wait for 10 minutes.
5. Reconnect supply lines / inlet pipes to the supply valve and check whether inlet and outlet are
working normally.
TROUBLESHOOTING
Test Mode
Note: Before entering the test mode, you should empty and drain the machine and ensure that there is no
water left in the drum. You can run a spin cycle and/or open the Coin Trap from the front of the unit to get all
water out. Please verify the coin trap knob is re-installed prior to proceeding.
To Enter Test Mode:
 Shut down the machine by pressing the “On/Off” button to power off the unit.
 Disconnect the plug from the power supply, wait 10 seconds and connect the power again.
 Press the buttons in sequence of Temp – Soil – Temp – Soil to enter Test Mode.
 “t01”will be displayed on the control panel.

Code Function Code Function Code Function
t01 Model Setting t06 Water Switch Test t11 Factory Test Mode
t02 Error Code Review t07 Water Heater Test t12 Water Inlet Valve Test
t03 Software Version t08 Drying Heater Test t13 Factory Test Mode
t04 Display Test t09 Wash Function Test t14 Factory Test Mode
t05 Pump Test t10 Spin Function Test t15 Factory Test Mode
Test Mode Notes
 t01, t03, t11, t13, t14, t15 are not used for service.
 To activate the Test Mode, Press the “Start/Pause” button once.
 Press the “Start/Pause” button again to start the function test.
 When the Test Mode is operating, press the “On/Off” button will stop the test and exit to status
for Test Mode selection.