EdgeStar CWD1550W - Error Codes

8
ERROR CODES
Error
Code
Error
description
Unit Action
Possible
Cause
Solution
E10
After 7
minutes, the
water level
doesn’t chan
ge
with valves
open
Unit will close
valve and stop
with Error code
display
Low Water
Pressure from
House Supply
If the washer fills very slowly, the water
pressure from water supply may be too
low. If the water inlet valve isn't leaking
and there are no other symptoms this
problem does not need to be corrected.
Water inlet
hose
Make sure that water faucet is turned on
and that the screens on the hoses are not
clogged / restricted.
Water inlet
valve
(The voltage on
the water inlet
valve is normal)
If the water pressure is good, try cleaning
the screens inside the water inlet valve
hose connection ports. If clean and free
from blockage, replace the water inlet
valve.
Water level
sensor or
control switch
(No voltage on
the water inlet
valve)
A water lever control switch controls how
much water enters the washing machine
by PCB. If the water level control switch is
defective, or more commonly, if the small
air pipe attached to the air bell restricted,
The switch will not be able to close the
electrical contacts to the washer fill valve.
CHECK THE AIR PIPE
CHECK THE WATER LEVER SENSOR
CHECK THE PCB and the inner
wire between PCB and the sensor
E11
There is
significant
water left in
the unit when
unit in standby
or at end of
cycle.
Unit will start
pump with door
locked, valve
closed, motor
stopped and
Error code will
be displayed
Water level
sensor or
control switch
The water level sensor can’t detect
water in the drum.
Tub Drain Hose
Assembly broken
If the air pipe connected to the water
level sensor is broken, the sensor will be
unable to detect the water level.