4
CLEANING AND MAINTENANCE
Exterior Cabinet:
Never use solvent based, abrasive cleaners, harsh chemicals, or steel wool to clean your unit as they
can damage the finish. The cabinet and door may be cleaned with a mild, non-abrasive detergent and
lukewarm water solution. Use a soft sponge and rinse with clean water. Wipe with a soft clean towel to
prevent water spotting.
During daily use it is recommended to wipe up any spills with dry soft cloth.
Internal Drum:
Never use solvent based, abrasive cleaners, harsh chemicals, or steel wool to clean the internal drum.
During daily use, use a soft cloth to wipe around the door, opening, and rubber seal to remove any
excess moisture and to maintain a water tight seal.
To clean the interior of the unit, all clothes must be removed from the drum. For liquid chlorine, add
directly to the fabric softener section. For powder tub cleaner, add directly to the main detergent
section. Use only cleaners labeled as safe for washing machines.
Select the cycle “Self Clean” and press “Start” to initiate the Self Clean cycle.
NOTE: It is recommended that you run the Self Clean cycle regularly to help remove detergent buildup
and other residue. Depending on how frequently the machine is used, you may need to run the Self
Clean cycle every month.
Detergent Dispenser:
1. Never use solvent based, abrasive cleaners, harsh chemicals or steel wool.
2. Remove the detergent dispenser from the unit by pressing downward on the release tab (shown
below) and gently sliding the dispenser drawer outward.
3. Once the dispenser drawer is removed, you can remove the fabric softener dispenser
compartment by gently lifting upward.
4. Place drawer under warm tap water and dry with soft cloth.
5. Reinstall the fabric softener compartment and gently slide the dispenser drawer back into the
unit.
Cleaning the inlet filter
If supply valve is fully opened and there is an insufficient amount of water coming through the hose you
may need to clean the inlet filters. The inlet filters are wire mesh screens located immediately inside
the hot and cold water line connections on the back of the unit. You will need a pair of needle nose
pliers to remove the filters for cleaning.
To Next Page
Loading...