EdgeStar CWD1550W - Service Dryer Heater; Fan Motor; Temperature Sensors

30
Service Dryer Heater / Fan Motor / Temperature Sensors
Description
Tools
Needed
Step 1:
Remove the
Top Cover
Assembly
Disassemble the two screws fixing the Top Cover Assembly on the back
of the unit. Slide the Top Cover backwards to remove.
Phillips Head
Screwdriver
Step 2
:
Check the
temperature
sensors
Phillips Head
Screwdriver
Step 3
:
Check and
replace the Fan
Flange
Assembly
Remove the 5 (five) screws fixing the Fan Flange Assembly
Clean / remove lint accumulation from duct / channel.
Phillips Head
Screwdriver
Step 4:
Check and
replace the
heater and
temperature
sensors.
Remove the 8 (eight) screws securing the cover.
Phillips Head
Screwdriver
1 – Temperature Sensor Drum-in
2 – Heater
3 & 4 – Manual Temperature Sensor
5 – Temperature Sensor, Drum-out