EdgeStar CWD1550W - Service the Pump; Inverter Motor; Inverter Module; Choke

31
Service the Pump / Inverter Motor / Inverter Module / Choke
Description
Tools
Needed
Step 1:
Remove the
back panel
Remove the 4 (four) screws that secure the back panel in place.
Phillips Head
Screwdriver
Step
2
:
Lay the unit side
down and
remove the
bottom cover.
Phillips Head
Screwdriver
Step 3
:
Open the Lint /
Coin Trap Door
Access Panel
Phillips Head
Screwdriver
Step 4:
Check and
replace the
Pump
Detach the pump by removing the 4 (four) screws that secure the pump
in place. Screws are accessible from within the Lint / Coin Trap Door
Access Panel.
Phillips Head
Screwdriver
Continued on next page…
Remove the 2 (two) screws that secure
the bottom panel to the rear of the unit.