EdgeStar CWF340DZ - OPERATION; Installation Check List before Operation; Using the Temperature Control Panel

- 11 -
3. DISASS
EMB
LY
LED light in lower zone
1. Remove four screws from the middle air duct board (figure
26)
Screw
Figure 26
2.
Remove the middle air duct board cover. Unscrew four
screws (figure 27)
Screw
Figure 27
3.
Ta
ke out the complete middle air duct board
(figure 28)
.
Figure 28
5.
Pul
l out the LED light connector
(figure 29)
Light connector
Figure 29
5.Loosen t
he LED light five fixer. Take out the LED light.
(figure 30)
Figure 30
6. The LED light is like below. (figure 31)
Figure 31
(Models： CWR1431TZ )
LED light in upper zone
1. Loosen one screws. (figure 32)
Figure 32
2. Unplug the led light connector. (figure 33)
Figure 33
3. Loosen two screws. (figure 34)
Screw
Figure 34
4. The LED light is like below. (figure 35)
Figure 35
LED
light in middle and lower zone
1. Remove five screws（figure 36)
Screw
Figure 36
co
nnector