EdgeStar Wine Refrigerator 6
Reversing the Door Swing
Follow the instructions below to reverse the door swing.
IMPORTANT: Before you begin, unplug the refrigerator. All parts
removed must be saved to do the reinstallation of the door.
To reverse the door from right swing to left swing:
1. Remove the three screws under the right bottom corner of the
cabinet that are used to hold the lower hinge to the glass door. Be
careful to hold the glass door with hands to prevent it from dropping
after removing the screws.
2. Pull down to remove the glass door. Place it on a padded surface
to prevent scratching it.
3. Remove the three screws that are used to secure the stainless
steel top insert with the cabinet. Push up and turn over to remove
the stainless steel top insert.
4. Unscrew the hexagonal-nut and remove the spring washer.
Unscrew the door shaft. Remove the two screws that are used to
secure the upper hinge with the cabinet.
5. Screw the door shaft at the opposite designated holes of the
upper hinge. Place the spring washer and screw the hexagonal-nut.
Turn over to install the stainless steel top insert.
To Next Page
Loading...
