EdgeStar CWR361FD - Page 16

- 16 -
3.
DISASSEMB
LY
3.
Unplug all cable connectors. (figure 36)
4. Press the plastic nail supporting the control board with
forefinger and thumb.
Figure 36
5. The control board is like below. (figure 37)
Figure 37
6. Disassemble the display board. (figure 38)
Figure 38
7. The display board is like below. (figure 39)
Figure 39
(Models：CWR181SZ)
1. Loosen four screws. (figure 40)
Figure
40
screw screw
2. Pull out the electrical box. (figure 41)
Figure 41
3.
Unplug all cable connectors. (figure 42)
Figure 42
4. Press the plastic nail supporting the control board with
forefinger and thumb. (figure 43)
Figure 43