EDGETEC SYSTEMS PTY LTD Part # 9-2100 MAY 2012
TriFlo Spa Bath Pump
Congratulations on the purchase of your new TriFlo spa bath pump. The TriFlo spa bath
pump has been specifically designed for spa bath applications to ensure that you have
optimum spa jet performance and many years of trouble free operation.
The TriFlo pump internal design allows the water to self drain so that there is no residue
water left in the pump when the spa is emptied in accordance with Local Health
Regulations.
TriFlo spa bath pumps are designed for spa bath operation only and should not be used in
chemically treated water or any other purpose without seeking written approval from
Edgetec Systems Pty Ltd for the application.
TriFlo Models and Operation Guide
Auto-Heat: The “Auto-Heat” TriFlo will help maintain your spa bath water
temperature during your spa by heat transfer. This pump is activated by the air
button installed on your bath.
Xtra-Heat: The “Xtra-Heat” TriFlo has the revolutionary flat plate 700watt Stainless
Steel heater built into the pump, this will maintain your spa bath water temperature
even in the largest spa baths. This pump is activated by the air button installed on
your bath.
EEZI-Touch: The “EEZI-Touch” TriFlo has the revolutionary
flat plate 700watt Stainless Steel heater built into the pump
and a bath mounted touch pad which allows you to
control the pump from the baths edge.
Depressing the touch pad button will turn your pump “on
or off”. When operating the Blue Led will light up.
The heating function will automatically come on once the pump has primed and
water is detected in the spa bath pump.
The Green indicator light on the touch pad is showing that the communication cable
from the pump is fitted correctly and that there is power to the spa bath pump
Sensa-Touch: The “Sensa-Touch” TriFlo has an integral flat plate 700watt Stainless
Steel heater built into the pump and a bath mounted touch pad which allows you to
control the Pump & Heater function from the baths edge.
Depressing the Pump button will turn your pump “On or Off”, if there is no water in the
spa bath or insufficient water in the pump the pump will automatically shut down to
protect your pump from running dry and causing potential damage.
The heating function will automatically come on once the pump has primed and
water is detected in the spa bath pump.
The Red heater indicator lights will flash in
sequence to indicate that the water is now
being heated. When the water temperature has
reached the setting chosen or the bath water is
at the set temperature the red lights L, M or H will
stay on depending on the setting chosen. To turn
the heating down press the heater button, each
time you press the heater button an indicator
light will turn off and the set temperature will be
reduced, when all the lights are off the heater is no longer active. To turn the heater
To Next Page
Loading...
