EDI CMUip-2212 Series - Default Chapter; Table of Contents

Table of Contents
Section 1 GENERAL ......................................................................................................... 1
1.1 Overview ................................................................................................................ 1
1.2 Channel Configuration ............................................................................................ 1
1.3 High Density Switch Pack (HDSP).......................................................................... 1
1.4 High Density Flasher Unit (HDFU) .......................................................................... 2
1.5 CMUip-2212 Programming ..................................................................................... 2
1.6 Detailed CMU Status .............................................................................................. 2
1.6.1 ECcom Software Interface ............................................................................ 2
1.6.2 Auxiliary Display Unit .................................................................................... 2
1.7 Serial Bus #1 .......................................................................................................... 3
1.7.1 Serial Bus #1 Message Types ....................................................................... 3
1.8 Serial Bus #3 .......................................................................................................... 3
1.8.1 Serial Bus #3 Message Types ....................................................................... 3
1.9 Failed State Action (LFSA, LFSA-R, NFSA) ........................................................... 4
1.9.1 Exit From FSA............................................................................................... 4
Section 2 MONITOR FUNCTIONS .................................................................................... 5
2.1 Cabinet Power Supply Monitor ............................................................................... 5
2.2 Conflicting Channels Monitor .................................................................................. 5
2.3 Serial Bus Monitor .................................................................................................. 5
2.3.1 Serial Bus #1 Error ........................................................................................ 5
2.3.2 Serial Bus #3 Error ........................................................................................ 5
2.4 Type 62 FSA Message ........................................................................................... 6
2.5 Lack of Signal Inputs Monitor ................................................................................. 6
2.6 Multiple Input Monitor ............................................................................................. 6
2.7 Yellow Clearance Monitor ....................................................................................... 6
2.8 Yellow Plus Red Clearance Monitor ....................................................................... 7
2.9 Local Flash Status .................................................................................................. 7
2.9.1 Local Flash Status Recovery ......................................................................... 7
2.10 Circuit Breaker Trip Status ................................................................................... 7
2.11 Flasher Unit Output Failed Alarm.......................................................................... 7
2.12 CMU Power Failure .............................................................................................. 8
2.12.1 Mains Voltage Level Sense ......................................................................... 8
2.12.2 Power Interrupt ........................................................................................... 8
2.12.3 Power Recovery .......................................................................................... 8
2.12.4 Power Up .................................................................................................... 8
2.12.5 Minimum Flash Interval ............................................................................... 8
2.13 Field Output Check ............................................................................................... 8
2.13.1 Field Check Mode ....................................................................................... 9
2.13.2 Field Check Status ...................................................................................... 9
2.14 Diagnostic Error ................................................................................................... 9
2.14.1 Ram Memory Diagnostic ............................................................................. 9
2.14.2 Nonvolatile Memory Diagnostic ................................................................... 9
2.14.3 Datakey Memory Diagnostic.......................................................................10
2.14.4 Internal MPU Monitor .................................................................................10
2.15 Recurrent Pulse Detection ...................................................................................10
2.15.1 Recurrent Pulse Detection Disable .............................................................11
2.16 Flashing Yellow Arrow (FYA) Protected-Permissive Monitoring ...........................11
2.16.1 FYA Configuration ......................................................................................11
2.16.1.1 Protected Turn Channel ....................................................................11
2.16.1.2 Permissive Turn Channel ..................................................................11
2.16.1.3 Opposing Through Channel ..............................................................11
2.16.2 Configuring the CMUip-2212 Fault Parameters For FYA ............................11