Need help?Do you have a question about the EDIFIER M3400 and is the answer not in the manual?
General| Type | 2.1 Speaker System |
|---|---|
| Total Power Output | 42W RMS |
| Subwoofer Power Output | 26W RMS |
| Frequency Response | 40Hz - 20kHz |
| Dimensions (Satellite) | 90 x 152 x 102 mm |
| Dimensions (Subwoofer) | 210 x 210 x 250 mm |
| Input Impedance | 10kΩ |
| Driver Unit | Satellite: 3½ inch (92mm) Subwoofer: 5 inch (131mm) |
| Satellite Power Output | 8W x 2 |
| Input Options | RCA, 3.5mm |
| Satellite Speaker Power Output | 8W x 2 |
| Signal-to-Noise Ratio | ≥85dB |
| Input Sensitivity | 450mV |
| Controls | Volume, Bass |
| Inputs | RCA, 3.5mm |
| Satellite speaker power | 8W x 2 |
| Audio inputs | RCA, 3.5mm |
Prevent electric shock by not removing covers and referring servicing to qualified personnel.
Follow instructions to prevent electric shock from rain, moisture, heat, and improper use.
Check speaker model and contact seller for any discrepancies or shipping damage.
Verify all components including subwoofer, satellite speakers, remote, and cables are present.
Connect satellite speakers and wired remote controller to the subwoofer's designated ports.
Connect the audio cable from the soundcard or other source to the subwoofer's line-in port.
Plug the AC power cord into a suitable AC wall outlet for your area.
Check power connection, power switch, and audio signal source for no sound issues.
Ensure secure cable connections, try a different outlet, and note slight hum may be normal.
Verify soundcard settings, drivers, cable integrity, and adjust volume controls.
Check subwoofer power and ensure bass volume settings on the system and computer are adequate.
To Next Page
