EDIFIER MP85 - User Manual

Manual
EDF100065 is in compliance with Directive 2014/53/EU. The full text of the EU
declaration of conformity is available at the following internet address:
Model: EDF100065
FCC ID: Z9G-EDF199
IC: 10004A-EDF199
P.O. Box 6264
Hong Kong
Tel: +852 2522 6989
Fax: +852 2522 1989
Printed in China
NOTICE:
For the need of technical improvement and system upgrade, information
contained herein may be subject to change from time to time without prior
For more information, please visit our website:
www.edifier.com
MP85
No sound
• Check if the speaker is ON.
•
• Check if there is a signal output from the audio source.
Cannot connect via Bluetooth
• Disconnect from any Bluetooth device by simultaneously pressing and
• Turn the volume down to the minimum level and simultaneously press
and hold the " " " " buttons for 3s to Reset.
•
operation is within that range.
•
• Please read the instructions carefully. Keep it in safe place for future reference.
• Use only accessories approved by the manufacturer.
• Install the instrument properly by following the instructions in the device
connection section.
• Using the product in a 0-35°C environment is recommended. Shipping and
storing the product in a 0-35°Cenvironment is recommended.
•
rain or moisture.
• Do not use this product near water. Do not immerge the product into any
liquid or have it exposed to dripping or splashing.
• Do not install or use this product near any heat source (e.g. radiator, heater,
stove, or other devices that generate heat).
•
•
•
(minimum 5cm is recommended).
• Do not force a plug into the jack. Before connection, check for blockage in
the jack and whether the plug matches the jack and is oriented to the right
direction.
•
to prevent from being swallowed by mistake.
• Do not open or remove the housing yourself. It may expose you to
dangerous voltage or other hazardous risks. Regardless the cause of
damage (such as damaged wire or plug, exposure to liquid splash or foreign
object falling in, exposure to rain or moisture, product not working or being
professional immediately.
For wireless product:
•
with the normal use of other electronic devices or medical equipment.
•
alarm system or other automated devices.
• Do not use the product in the vicinity of a pacemaker within a 20cm range.
medical devices.
Excessively loud music may lead to hearing loss. Please keep the
volume in a safe range.
English
Correct Disposal of this product. This marking indicates that this
product should not be disposed with other household wastes. To
prevent possible harm to the environment or human health from
uncontrolled waste disposal, recycle it responsibly to promote the
sustainable reuse of material resources.To return your used device,
please use the return and collection systems or contact the retailer
where the product was purchased. They can take this product for
environmental safe recycling.
WARNING!
•
same or equivalent type.
•
• Never disassemble, hit with force, squeeze batteries or dispose of batteries
•
•
swollen, eaking, discolored, having odor or any abnormal appearance, stop
using it.
•
•
applicable laws and regulations in your locality.
•
•
• Never use strong acid, alkali, gasoline, alcohol, or other chemical solvents to
• The product must be used at an altitude of lower than 2000m.
Red LED Steady Lit = Charging
USB Power Plug
Bluetooth disconnection
product.
MP85 speaker
User manualLanyard
USB-A to USB-C
charging cable
Blue LED Blinks
Bluetooth connection and playback
Blue LED Blinks
Reset
Indicator status
Power output: 2.2W
Frequency response: 230Hz-17kHz
Input: 5V 500mA
Declaration for EU
Frequency Band: 2.402GHz ~ 2.480GHz
RF Power Output: ≤10 dBm (EIRP)
There is no restriction of use.
Bluetooth
Settings
EDIFIER MP85
DEVICES
Bluetooth
2:12
Blue LED Steady Lit

English
English
English
English
English
Blue LED Blinks
6 times rapidly
1
2
1. Scan the QR code for the app.
English
EN Important safety instruction
What’s in the Box?
Functional Operation
Operating Instructions
Edifier Connect app
Specifications
Troubleshooting

󾙓
󾙓󾙗

󾙓
󾙓󾙗

󾙓
󾙓󾙗
󾙓󾙗
󾙓󾙗
󾙕

Summary

Important Safety Instructions

General Safety Guidelines

Read instructions carefully, use approved accessories, maintain ventilation, and avoid water exposure.

Wireless Product Precautions

Warnings for wireless operation near medical devices, pacemakers, and in restricted areas.

Battery Safety Warnings

Critical warnings on battery replacement, heat exposure, disassembly, and handling leaks.

Product Operation and Setup

Whats in the Box

Lists all components included in the MP85 portable Bluetooth speaker package.

Functional Operation Overview

Illustrates the physical layout and key functions of the speaker's controls and ports.

Operating Instructions

Bluetooth Connection and Playback

Step-by-step guide to pair the speaker with devices and start audio playback via Bluetooth.

Bluetooth Disconnection

Instructions on how to properly disconnect the speaker from a connected Bluetooth device.

Resetting the Speaker

Procedure to reset the speaker to its factory default settings for troubleshooting.

Indicator Status Lights

Explanation of the LED indicator lights and what they signify during operation.

Specifications and Support

Technical Specifications

Details power output, frequency response, input requirements, and EU declaration.

Edifier Connect App

Information and instructions for downloading and using the Edifier Connect mobile application.

Troubleshooting Common Issues

Guidance on resolving 'No Sound' and 'Cannot connect via Bluetooth' problems.

EDIFIER MP85 Specifications

General

Bluetooth Range	10m
Built-in Microphone	Yes
Input Sensitivity	450mV±50mV
Power Supply	5V/1A
Supported Profiles	A2DP, AVRCP, HFP
Charging Time	2-3 hours