EDIFIER MP100 Plus - Operating Instructions; Bluetooth Playback; Bluetooth Hands-Free Phone Function; LED Instructions

■ Operating instructions
1. When the speaker is powered on,
select "EDIFIER MP100 Plus" in your
device setting to connect.
2. After the connection is successful, the
speaker will emit a prompt, then start playing music.
When there is a Bluetooth connection between the
phone and the speaker, and there is an incoming call:
• Press and hold " " to reject a call
• Press " " to answer, then press to end a call
• When calling, press and hold " " to transfer the call to the phone
■ LED instructions
ChargingStatus
Non-charging/
fully charged
Blue LED blinks rapidly Blue LED blinks rapidly
Blue LED steady lit
/
Red LED steady lit
Red LED steady lit
Bluetooth pairing
Bluetooth connected
Power off
Red LED blinks slowly Blue LED blinks slowlyBluetooth hidden
Note:
1.
Please make sure your device supports A2DP (Advanced Audio Distribution Profile) /
HFP (Handsfree Profile) profiles.
2. Pin code for connection is "0000" if needed.
Note:
1. When the speaker enters the Bluetooth hidden state, it cannot be connected with
the mobile phone.
2. Press the Bluetooth switch to enter the Bluetooth pairing state and then connect.
Bluetooth playback
●
Bluetooth hands-free phone function
●