How to Pair Your Speakers 11
Pair soundbar with wireless active subwoofer
Soundbar has been paired with subwoofer before leaving the factory. Hence the wireless connection will
resume automatically when both soundbar and subwoofer are powered on and the red indicator is lit. If the
wireless connection fails to resume, please follow these steps below to re-pair.
1. Power on the subwoofer, the red indicator should blink in a breathing pattern, which means no
active wireless connection.
2. Press and hold the "Pair" button on back panel of the subwoofer for 2 seconds to put it into pairing mode.
The red indicator will blink rapidly.
3. Press and hold the "Pair" button on back panel of soundbar to put it into pairing mode.
4. Wait until the red indicator on subwoofer is lit constantly. The pairing is complete and wireless
connection is made.
.
LED indicator blinks in a breathing pattern: subwoofer is disconnected and enters standby mode
LED indicator blinks rapidly: subwoofer enters pairing mode
LED indicator is constantly lit: subwoofer is connected.
S70DB
To Next Page
Loading...