Pair soundbar with right rear surround speaker (SR)
Soundbar has been paired with right rear surround speaker before leaving the factory. Hence the wireless
connection will resume automatically when both soundbar and SR speaker are powered on and the red
indicator is lit. If the wireless connection fails to resume, please follow these steps below to re-pair.
1. Power on SR speaker, the red indicator should blink in a breathing pattern, which means no active
wireless connection.
2. Press and hold the "Pair" button on back panel of SR speaker for 2 seconds to put it into pairing mode.
The red indicator will blink rapidly.
3. Press and hold the "Pair" button on back panel of soundbar to put it into pairing mode.
4. Wait until the red indicator on SR speaker is lit constantly. The pairing is complete and wireless
connection is made.
.
LED indicator blinks in a breathing pattern: SR speaker is disconnected and enters standby mode
LED indicator blinks rapidly: SR speaker enters pairing mode
LED indicator is constantly lit: SR speaker is connected
Right rear surround speaker (SR)
To Next Page
Loading...