3
■ How to Operate
I. Charging
II. Power ON/OFF
Power ON
Power OFF
Press and hold the multifunction button
for 3 seconds
Press and hold the multifunction button
for 3 seconds
Function Operation
Blue light lit for 1
second
Orange light lit for 1
second
Pairing
Turned on and unconnected: press and
hold the multifunction button for 2 seconds
Turned off: press and hold the
multifunction button for 5 seconds
Orange and blue
light blinks
alternately
Indicator
During use, if only orange indicator blinks, it indicates low battery level and
please use it after fully charged.
Orange light steady lit = charging Orange light off = fully charged
Charging time: about 4 hours for a full charging
Warning: The rechargeable batteries that provide power for this product
must be disposed properly for recycling. Do not dispose of batteries in fire
to prevent an explosion.
EDIFIER W820BT
III. Pairing and Connection
1. Bluetooth connection
• When turned off, press and hold the multifunction button for 5 seconds
until the orange and blue light blinks alternately, it enters pairing status.
• Set Bluetooth phone to search for and pair with “EDIFIER W820BT”; Wait
until hearing a prompt tone and the blue light will blink slowly, then the
pairing is successful.
Note:
•
If fail to pair within 2 minutes it will exit pairing mode, and the headphone
will auto-turn off if not connected within 5 minutes after timeout.
• Pin code for connection is “0000” if needed;
• After pairing is complete, the
headphone and mobile phone
will remember each other, and
the headphone will auto-connect
to the last connected device
when used next time;
To Next Page
Loading...
Need help?
General
Weight and Dimensions
