What to do if my EdilKamin Simpaty Stove remote control is not working?
If your EdilKamin Stove remote control isn't working, there are a couple of things to check. First, make sure you're not too far from the stove; try moving closer. Second, the remote control battery might be flat, so check the battery and replace it if needed.
Why does my EdilKamin Simpaty not ignite?
If your EdilKamin Stove doesn't ignite, it could be due to an accumulation of unburnt residue in the combustion chamber. Clean the combustion chamber to resolve this issue.
What to do if the synoptic panel is off on my EdilKamin Simpaty?
If the synoptic panel on your EdilKamin Stove is off, it's likely due to no mains voltage. Check that the power cable is properly connected. Also, check the fuse on the power socket.
What to do if my EdilKamin Simpaty displays “Battery check” on the synoptic panel?
If your EdilKamin Stove displays “Battery check” on the synoptic panel, it means the backup battery inside the control board is flat. Replace the backup battery to solve this.
Why is the output air from my EdilKamin Simpaty not hot?
If the output air from your EdilKamin Stove isn't hot, it could be due to too much soot in the exchanger. Clean the hearth exchanger using the specific rods.
What to do if the flame does not appear on my EdilKamin Simpaty?
If the flame does not appear on your EdilKamin Stove (remember that it should appear 5 minutes after pressing the 0/1 key), it may be because the feed screw has not been filled. Fill the feed screw.
Why doesn't the ignition/shutdown phase start at the preset time on my EdilKamin Simpaty Stove?
If the ignition/shutdown phase doesn't start at the preset time on your EdilKamin Stove, it's likely due to incorrect settings related to the current time program activation or the activation of the daily program. Verify these settings according to the guidelines.
To Next Page
General