Edirol StudioCanvas SD-20 - Page 46

45
Getting connected and installing drivers (Macintosh)
OMS settings
1
From the CD-ROM, drag the Driver-OMS Driver-OMS Settings folder to
the hard disk of your Macintosh to copy it.
fig.3-4
2
In the Opcode-OMS Application folder where you
installed OMS, double-click OMS Setup to start it up.
fig.3-5_35
3
If a dialog box like the one shown
here appears, click [Turn It Off]. A
confirmation dialog box will then
appear, so click [OK].
fig.3-6_35
4
The Create New Setup dialog box will
appear.
Click [Cancel]. If you accidentally
clicked [OK], click [Cancel] in the next
screen.
fig.3-7
5
Choose “Open” from the File menu.
From the OMS Settings folder that
you copied in step 1, select the SD-20
USB file, and click [Open].
fig.3-8_35
A screen like the one shown here will
appear.