55
Getting connected and installing drivers (Macintosh)
■ Installing the SD-20 driver (FreeMIDI)
Use the following procedure to install the SD-20 driver. The included SD-20
FreeMIDI driver is an add-on module for using the SD-20 with FreeMIDI. In
order to use it, FreeMIDI must be installed on the hard disk from which
you started up.
1
Exit all currently running software (applications).
If you are using a virus checker or similar software, be sure to exit this as well.
2
Prepare the CD-ROM.
Insert the CD-ROM into the CD-ROM drive.
3
Double-click the SD-20 FM Serial Driver-E icon (found in the Driver -
FreeMIDI Driver folder of the CD-ROM) to start up the installer.
4
Click [Install].
5
A dialog box will inform you that you will need to restart your Macintosh
when installation is finished. Click [Continue].
6
When the installation is complete, click [Restart].
FreeMIDI settings
1
From the CD-ROM, copy the Driver - FreeMIDI Driver - Free MIDISettings
folder onto the hard disk of your Macintosh.
2
Open the FreeMIDI Applications folder from the location into which you
installed FreeMIDI, and double-click the FreeMIDI Setup icon to start it up.
3
When “OMS is installed on this computer...” appears, click [FreeMIDI].
4
The first time the software is started up, a dialog box saying “Welcome to
FreeMIDI!” will appear. Click [Continue].
5
When the FreeMIDI Preferences dialog box appears, click [Cancel].
6
When the About Quick Setup dialog box appears, click [Cancel].
To Next Page
Loading...
