20
Product inspection: Inspect the equipment for shipping
damage. If you have discovered any damage,
immediately le a claim to the carrier.
Read and Follow All Instructions: All the safety and
operating instructions should be read prior to and
followed while operating this product.
Attachments: Do not use attachments that are not approved
by the product manufacturer.
Water and Moisture: This product is not waterproof.
Power Sources: This product should be operated only from
the type of power source specied.
Wire Protection: Ensure all connected wiring is routed
correctly to avoid damage including pinching, excessive
bends, or compression.
Power Lines: Always use caution and avoid operating this or
any connected equipment near uninsulated power lines
or any other hazards.
Servicing: There are no user serviceable parts except the
battery (replacement only). Do not attempt to service this
product or remove covers other than the battery cover.
Heat: The product should be operated away from heat
sources such as radiators, heat registers, stoves, or
other products that produce heat.
Maximum input Voltage: Ensure that the voltage applied
to the power connector does not exceed 12V. Higher
voltages may damage the equipment!
Replace battery only with a new one of the same type.
Recycle or dispose used electrical and electronic devices
properly.
►SAFETY REQUIREMENTS
To Next Page
Loading...