3
3) Press the “TARE” key and the display will show “9.853” then the number behind the decimal point will
flash.
4) Press the “TARE” key and the numbers will cycle up one number each time that the “TARE” key is
pressed. Stop at the new gravity setting number.
5) Press the “UNITS” key to move to the next number to the right to be changed.
6) Press the “TARE” key to cycle the number up from the old number to a new number each time that the
“TARE” key is pressed. Stop at the new setting number.
7) Repeat steps 6 and 7 until all the digits have been changed as required.
8) When all the numbers have been correctly changed, press and hold the “TARE” key and press the
“UNITS” key. The display will show “END” and will return to the weighing mode.
Automatic shutoff programming
1) With the scale in the off position, press and hold both the “TARE” and “UNITS” keys, and then press the
“ON/OFF” key, the display shows “CAL”
2) Press the “UNITS” key three times to get into the automatic battery shutoff setting mode.
3) The display will show “AOFF”. Press the “TARE” key to begin selection of the battery automatic shutoff
time. The display will show 120.
4) Press the “UNITS” key to toggle though the available automatic battery shutoff times. The selections are
120 seconds, 240 seconds, 360 seconds, 720 seconds, or OFF.
5) When the desired shutoff time is shown, press the “TARE” key. The display will show “END” and
will return to the weighing mode.
Care and use:
Remove residues from scale exterior with moist cloth, taking care that no liquid is allowed to enter the case.
Internal moisture, use under heat lamps or use near steam tables could damage or destroy the electronic circuitry.
Using the platform as a cutting surface is also not recommended as any high impact to the underlying load cells
can reduce their accuracy and functional life.
Warranty:
Edlund scales are warranted against defects in material and workmanship for a period of one year from the date of
purchase. During the warranty period, Edlund will repair or replace at its option, at no charge, defective parts
provided the customer calls 1-800-772-2126 for a return authorization number (RA#) and the scale is returned in an
adequately protecting shipping carton. Please mail to the Edlund Company Service Dept., 159 Industrial Parkway,
Burlington, VT 05401.
Note: This warranty does not apply to any scale damaged by accident or misuse, exposed to radioactive or
corrosive materials or as a result of service modification by other than Edlund Service Department. The Edlund
Company gives no other expressed or implied warranty.
To Previous Page
Loading...