Ednet 91610 - User Manual

Laminator, A4
Manual
91610
The laminator is only suitable for laminating documents. Any other use or modification shall
be deemed to be improper and involves substantial risk of accidents.
Important advice about safety
1. Read through these operating instructions carefully and completely before using the
machine for the first time.
2. Only put the machine on a flat and dry surface. It must be freely accessible from all sides.
It is not recommended to use an extension cable!
3. Do not open or repair the laminating machine yourself but take it to your specialized
dealer whenever it is damaged, or contact our service hot line.
4. Only use films of the correct size (up to DIN A4 max.) and thickness (80 to 100 microns).
Films that are too thin cause a blockage of the film in the machine.
5. Do not touch the hot surface of the machine after it has started up.
6. The laminating machine is not allowed - for safety reasons - to be used by children,
unless they are supervised by an adult.
7. Never use the machine outdoor or near water.
8. Hot lamination: do not laminate in this mode any materials that are sensitive to heat
with this machine, like thermo-fax paper for example. These materials are only suitable
for cold lamination.
9. Do not pour or spill any liquid into the machine or onto it.

Summary

Important Advice About Safety

Read Instructions and Setup

Read operating instructions carefully before first use.

Safe Placement and Environment

Place on flat, dry surface, accessible from all sides. Avoid extension cables.

Professional Repair

Do not open or repair yourself; contact dealer or service hotline for damage.

Film Usage Guidelines

Use correct film size (DIN A4 max.) and thickness (80-100 microns).

Hot Surface Caution

Child Supervision

Water and Outdoor Use

Material Sensitivity

Liquid Spillage Warning

No Metal Objects

Commercial Use Limitation

Socket Accessibility

Starting Up the Laminating Machine

Powering On and Heating

Film and Material Placement

Laminating Film Guidelines

Insertion and Feeding

Output and Cooling

Powering Off

Blockage Handling Note

Turn off immediately if a blockage occurs; do not feed more foil.

Clearing a Film Blockage

Utilizing the ABS Button

Use the ABS button on the back to resolve blockages.

Procedure for Clearing Blockage

Switch off, cool down, press ABS button, pull film out gently.

Ednet 91610 Specifications

General

Type	Hot laminator
Format	A4
Control type	Buttons
Warm-up time	3 min
Product color	White
Preheating time	- min
Ready indicator	Yes
Built-in display	No
Housing material	Plastic
Lamination speed	400 mm/min
Maximum film thickness	125 µm
Minimum film thickness	80 µm
Maximum lamination width	230 mm
Maximum document thickness	- mm
AC input voltage	220-240 V
AC input frequency	50 Hz
Power consumption (typical)	260 W
Harmonized System (HS) code	84729080

Weight and Dimensions

Depth	135 mm
Width	355 mm
Height	58 mm
Weight	700 g