Ednet X10 CD - User Manual

Shredder X10 CD
with separate cutting unit for CDs/DVDs and credit cards
Manual
91608
This device is solely intended to shred/destroy a maximum of 10 (unstapled) sheets of paper
per operation. Any other use is deemed incorrect use and thus will invalidate the extended
warranty and endanger your safety. The device cannot shred laminated paper or plastic
sleeves and will be irreparably damaged if used in this way.

Summary

Safety Precautions

General Safety and Usage Warnings

Essential safety guidelines for operation, handling, and environmental conditions, including preparation and material restrictions.

Placing the Shredder

Important Notice on Basket Fit

Release mechanism requires proper basket alignment for device function.

Operating the Shredder

Shredder Switch Positions

Explanation of the three operating modes for the shredder: AUTO, REV, and OFF.

Shredder Specifications and Operation

Capacity and Separate Cutting Unit

Details on paper shredding capacity and the dedicated unit for CDs/DVDs and credit cards.

Operation, Overloading, and Overheating

Instructions for shredding paper, and guidance on handling paper jams and motor overheating.

Technical Specifications and Compliance

Removal of Leftover Paper and Turning Off

Procedure for removing paper scraps and turning the device off.

Detailed Technical Data and Warnings

Provides cutting specifications, electrical data, security levels, and radio interference warnings.

Ednet X10 CD Specifications

Cutting Specifications

cutting action	Cross-cut
cut size	5 x 18 mm
cutting capability	10 sheets

Input Specifications

input slot width	220 mm
input slot width for CDs/DVDs	120 mm
input voltage	230-240 volt AC, 50 Hz, 1.2 A

Performance

feed rate	1.5 m/min.
paper basket capacity	21l
protection class	P4