Building a Biplane
Tail Assembly
Rudder Assembly to Tail
Wing Assembly
STEP
1
STEP
2
STEP
3
Single Plane Matrix
Using 2-way connectors
Connect the three
rudders to the left,
right, and top-back of
the tail assembly as shown.
Cube
Using 2-way and
90° connectors
Hub
Using 2-way connectors
Hub
Using 2-way connectors,
attach coin-to-connector
and connector-to-connector.
Extra Strength
By doubling connectors you can
strengthen any connection.
(This shows two 4-way connectors.)
Top View
Front View
4 1 penny
8 8 8 pennies
(75) 2-way (35) 90°
Side View
4 2 4 pennies
Coins needed to build your biplane:
(51) pennies (2) nickels
Coinstruction connectors needed to build your biplane:
2X
6 3 pennies
3X
4
30 pennies44
2X
1a
1b
1b
1c
Basic and Starter Shapes
Use these illustrations to build basic and “starter” shapes. Once
you know how to build these basic shapes, you will be able to
build anything your imagination allows! Remember, not all kits
have every kind of connector. Check the description to the right
to see which connectors are included in this kit.
1a
1a
1b
1b
1b
1c
1c
To Next Page
Need help?
General
