Building a Skyscraper
Base
Base Assembly
Post Attachment 1
STEP
1a
STEP
1b
Walls
STEP
2
Roof
STEP
3
Roof Tower
STEP
4
STEP
5
Wall Attachment 1
STEP
6
Post Attachment 2
STEP
7
Single Plane Matrix
Using 2-way connectors
Cube
Using 2-way and
90° connectors
Hub
Using 2-way connectors
Attach to middle section of each
from Base Assembly (Step 1b) as shown.
Hub
Using 2-way connectors,
attach coin-to-connector
and connector-to-connector.
Extra Strength
By doubling connectors you can
strengthen any connection.
(This shows two 4-way connectors.)
(52) 2-way (28) 90°
Coins needed to build your skyscraper:
(69) pennies
Coinstruction connectors needed to build your skyscraper:
Basic and Starter Shapes
Use these illustrations to build basic and “starter” shapes. Once
you know how to build these basic shapes, you will be able to
build anything your imagination allows! Remember, not all kits
have every kind of connector. Check the description to the right
to see which connectors are included in this kit.
8
(20) 3-way
4
20 pennies 8 8 pennies
4X
3
3 pennies
1
2 pennies
48 4 pennies
1616 32 pennies
8 Base Assembly from Step 1b 8
4X
Base Assembly1b
A
B
C
D
To Next Page
Need help?
General
