Edwards EDS 200

EDS
200 300
Short circuit current rang according
IEC/EN 60947 suitable for motors with
eciency class IE3.
225 A
Second protecve earth (ground)
conductor
Must be ed with cross-seconal area at least equal to
phase conductor size
Cooling fan for heat exchanger
Supply voltage 1-phase 24 V DC
Nominal current consumpon 5 A
Pump body thermal snap switch
Supply voltage 1-phase 6 - 230 V AC
Rotor speed 6600 rpm 7500 rpm
Min. permissible motor speed
1)
1200 rpm
Protecon class
Water cooled
Air cooled
IP 54
IP 20
Approx warm-up me to a temperature
of 40 °C (stator), with a cooling-water
ow of 4 l·min
-1
@20°C
60 min
Oil lling Ultragrade® Endurance Extend 110
Oil quanty
Drive (gearbox)
Inlet side
1250 ml
250 ml
Inlet ange ISO 63
Exhaust ange NW 40
Materials
Rotors, Stators, Shas, Gearbox
Cast SG Iron
Seals
PTFE and uroelastome
Coupling cover Cast grey iron, steel, aluminium, brass, rubber
Timing gears Steel
Closed water circuit lling Drystar water mixture 50:50
Oil lling Synthec
Weight (approximate) 420 kg
Water
Water connecon G½˝ female threads
Water supply temperature 5 °C - 35 °C
Required water pressure dierenal (to
achieve minimum 8 l/min)
0.2 bar
Maximum supply pressure 7 bar(g)**
Primary cooling circuit volume
(Drystar water mixture volume in case of
variant with indirect cooling)
6 l
Purge
Connecon G¼˝ female thread
Purge gas supply pressure range 4 to 10 bar (g)
Purge gas regulated pressure > 2.2 bar (g)
Page 18
A41802880_C - Technical data