Why Efco Blower won't start?
If your Efco Blower engine won't start or shuts off shortly after starting, here's what to check: 1. See if there's a spark. If not, try again with a new spark plug (RCJ-7Y). 2. If the engine is flooded, follow the procedure on page 20. If it still doesn't start, repeat with a new spark plug.
What to do if Efco Blower doesn't accelerate properly?
If the Efco Blower engine starts, but doesn't accelerate correctly or doesn't run properly at high speed, the carburetor needs adjustment. Contact an Authorized Service Center to adjust the carburetor.
Why does my Efco Blower engine lack power and emit smoke?
If your Efco Blower's engine doesn't reach full speed and/or emits excessive smoke, check the following: 1. Ensure you're using fresh gasoline and the correct two-stroke engine oil mixture. 2. Clean the air filter according to the maintenance instructions. 3. If the issue persists, the carburetor may need adjustment; in such cases, seek assistance from an Authorized Service Center.
What to do if my Efco Blower has low airflow?
If your Efco Blower engine starts but the airflow is weak, check these items: 1. Make sure the safety guard isn't blocked; clean it if necessary. 2. Inspect the impeller. If it's damaged, contact an Authorized Service Center. 3. Check the impeller housing and tubes for blockages and clean them.
How to fix idle on Efco Blower?
If your Efco Blower's engine starts, runs, and accelerates, but won't idle, try this: Adjust the idle speed screw “T” (Fig.66, pag.36) clockwise to increase the speed; see chapter Manutenzione carburatore.
To Next Page
General
