Efco stark 25 tr User Manual (English)

Questions and Answers:

A
Amanda KnightAug 5, 2025
What to do if my Efco stark 25 tr engine doesn't start or stalls?
- S
  Scott ColemanAug 5, 2025
  If your Efco Grass trimmer engine doesn't start or stalls shortly after starting, there could be two reasons. First, there might be no spark. Check the spark plug for a spark; if there isn't one, try again with a new RCJ-7Y spark plug. Second, the engine might be flooded. Follow the procedure on page 26 of the manual. If it still doesn't start, repeat the procedure with a new spark plug.
J
Jessica HendersonAug 11, 2025
How to fix Efco Grass trimmer that starts but doesn't idle?
- C
  Cameron BrooksAug 11, 2025
  If your Efco Grass trimmer engine starts, runs, and accelerates, but does not idle, the carburetor likely needs adjustment. Adjust the idle speed screw “T” (Fig.95, pag.50) clockwise to increase the speed; see chapter Manutenzione carburatore.
B
Benjamin Bell DDSAug 17, 2025
Why Efco stark 25 tr Grass trimmer engine doesn't reach full speed and emits smoke?
- C
  colejenniferAug 17, 2025
  If your Efco Grass trimmer engine doesn't reach full speed or emits excessive smoke, check a few things: * Ensure you're using fresh gasoline and the correct 2-stroke engine oil. * Clean the air filter following the instructions in the air filter maintenance chapter. * It may be necessary to contact an Authorized Service Center to adjust the carburetor.
S
Sarah EllisAug 23, 2025
What to do if Efco stark 25 tr Grass trimmer starts but doesn't accelerate correctly?
- L
  lisa62Aug 23, 2025
  If the engine of your Efco Grass trimmer starts but doesn't accelerate properly or doesn't run correctly at high speed, the carburetor needs adjustment. Contact an Authorized Service Center to adjust the carburetor.
T
Thomas MillerAug 28, 2025
What to do if Efco stark 25 tr cutting attachment is not rotating?
- J
  Joy Hill DDSAug 29, 2025
  If the engine of your Efco Grass trimmer starts and runs, but the cutting attachment is not rotating, the clutch, bevel drive, or transmission shaft may be damaged and need replacement. Contact a Servicing Dealer.