395823110a 22
Maintenance of the glass
Properly operated, your glass door will not get coated with thick tar like
conventional stoves. If this does occur you may have to resort to using a
glass cleaner. However by using dry wood, much of the tar on the glass
will burn clean, when the appliance is run at high temperature.
Clean the ceramic glass when cold using commercial products sold for this
purpose, or warm water with a drop of vinegar.
CAUTION: NEVER OPERATE YOUR STOVE WITH BROKEN GLASS.
Replacement of the glass
1. Open the door as indicated below.
2. Remove the 4 fixing screws and fit the new glass.
3. Replace the seals.
4. Install the 4 screws. Do not over-tighten the screws.
When replacing glass always replace glass seals.
Other maintenance
Clean the unit, the flue outlet, and the chimney at the end of each heating
season or more often if the use of the stove, or the fuel make it necessary.
For cleaning purposes the baffle plates can be removed without any tools.
This gives access to the cleaning flap of the smoke flue and it is even
possible to reach the flue outlet.
Summer shut down
Ashes shall be removed, and disposed of in a steel container with a tightly
fitting lid and moved outdoors immediately. Other waste shall not be
placed in this container.
Remove all remaining ash and cinders from the unit, close all the stove
doors. If the room is damp, possibly place some absorbent crystals inside
the stove and/or disconnect it completely from the chimney.
To Next Page
Loading...
