11
Erroneous entry of code numbers disable time period 13 secs.
If a wrong code number is entered, release of the door is not effected.
Furthermore the membrane keypad is electronically disabled for 13
secs. (disable time). Only once this disable time has expired a
completely new entry is possible again
(see operation ot the code lock).
Battery change
If battery capacity has been more or less used up (approx. 50 actuations
left), a red LED indicator will blink on the membrane keypad during the
door unlocking period of 3 secs. This indicator advises the user/operator
of the necessity of an immediate battery change. The stored current
code number is retained during the battery change procedure.
Error reset
In the event of an equipment error or loss of the code number it is
possible to reset equipment (see page 22 for further details). For this
purpose the outer code lock furnitures has to be removed, in order to be
able to operate the reset key on the rear side of the code lock (outer
plate). In order to do this, first of all (with battery connected) the E key
on the keypad has to be pressed and subsequently the aforementioned
reset key within 13 secs. By way of this reset procedure the code lock is
again programmed to the original ex-works setting. For further operation
details on this subject see the section
Functional testing.
LLPlease take note:
During operation the door handle of the code
lock
,
s outer furniture must not be subjected to a prior load. The
membrane keypad of the code lock may be actuated manually only
(under no circumstances using articles such as keys, pens etc.).
LLInstructions on care:
The code lock may only be cleaned using a
moist cloth with a mild, non-abrasive cleaning agent. Avoid moisture
penetrating the code lock furnitures.
Right reserved to effect technical changes.
To Next Page
Loading...