7
DRIVING SAFELY
General instructions before riding:
1) Tire pressures: Check the tires for correct inflation
and for any signs of physical damage.
2) Brake check: Squeeze the brake lever (front and
rear) as hard as you can, push the scooter forward and
check the braking resistance.
3) Safety Circuit Breaker: It is a safety switch placed
under the seat. It might be turned
OFF
when delivery
and technical service, and it must be turned
ON
before
riding.
This symbol informs you that
exposure to high voltage can
cause shock, burns and even
death.
The high voltage components on
the motorcycle should be serviced
only by technicians with special
training.
4) Battery Check: Make sure your scooter is enough
charged for your ride and always check the battery
indicator while you are riding. Ensure that battery does
not get too low too often. Sometimes the voltage meter on
left side of dashboard would be more accurate than bars
battery indicator, this is normal because of the lithium
battery properties. Always charge the battery before using
and after every use. More frequently charging is better for
battery life.
5) Ready to ride: Make sure the side stand is removed
and the killswitch is in “GO” position before riding. If some
of that sensors are not ready, the scooter will not respond
to the accelerator.
6) Steering: Check the handlebar for any damage.
Squeeze the front brake and push the handlebar up and
down to check for any unusual noise. Move the handlebar
in all directions to check for any loose parts or
obstructions. Any problems should be corrected before
use.
7) Suspension: Check the correct working of the fork and
the rear suspension before riding.
To Next Page
Loading...