EasyManuals Logo

Eggtimer Rocketry Eggtimer Quark User Manual

Default Icon
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
General Assembly Information
We’re sure that you are ready get started, but before you do you will need to get some tools
together. The tools that you will need are:
___ Low-wattage soldering iron, 15W or less, with a fine conical tip
___ Small needle-nose pliers
___ Small diagonal cutters
___ Tweezers to handle the SMT parts
___ A mesh sponge for cleaning the tip of your soldering iron
___ A tinning block to clean and tin your iron as you go along
___ A lighted magnifier… unless you have Superman’s eyes
___ A jeweler’s loupe or small 10x magnifier, for inspecting the SMT solder joints
___ A well-lighted place to work, preferably with a wood or metal surface,
also preferably not carpeted
___ Some PAPER masking tape (do NOT use Scotch® tape or electrical tape)
Each installation step has a check-off line, we strongly recommend that you check them off as
you go, and that you perform the steps in sequence. We have listed the steps in order to make
it easiest to assemble the Quark, deviating from them isn’t going to make your life any easier.
Each step is pictured, so you can see exactly what you need to be soldering. Looking at the
pictures as you go will help prevent you from soldering the wrong thing, or putting something
in the wrong way.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Eggtimer Rocketry Eggtimer Quark and is the answer not in the manual?

Eggtimer Rocketry Eggtimer Quark Specifications

General IconGeneral
BrandEggtimer Rocketry
ModelEggtimer Quark
CategoryController
LanguageEnglish