Ego Power+ SNT2800 - Troubleshooting: Performance Issues; Auger and Snow Throwing Problems

56V LITHIUM-ION CORDLESS SNOW BLOWER — SNT2800/SNT2800-FC 39
PROBLEM CAUSE SOLUTION
The auger motor is on
but the auger does not
turn.
◾
The shear pin is broken.
◾
Replace the shear pin
following the section
“REPLACING THE SHEAR
PIN” in this manual.
After passing, the
snow blower leaves a
layer of snow on the
ground.
◾
The scraper bar is worn.
◾
Replace the scraper bar
following the section
“REPLACING THE
SCRAPER BAR” in this
manual.
◾
The skid shoes are set too
low to place the scraper
bar too far from the
ground.
◾
Adjust the height of the
skid shoes following the
section “TO ADJUST THE
HEIGHT OF SKID SHOES”
in this manual.
The snow blower
throws less snow.
◾
The augers are worn.
◾
Auger speed may be too
low.
◾
Contact EGO service
center for repair.
◾
Increase the auger speed.
The handles fail to be
heated.
◾
The heating function will
turn off automatically
when the snow blower is
inactive for 10 minutes.
◾
Press the handle-heating
switch to restart the
heating.