8
EN
SNOW SHOVEL ATTACHMENT — SSA1200
SPECIFICATIONS
Rated Voltage 56 V
No-load Speed
1420±10% rpm
1750±10% rpm
Clearing Width 30 cm
Throw distance Up to 7.5 m
Intake Height 15 cm
Recommended Operating
Temperature
-10-10°C
Recommended Storage Temperature
*For the appliance WITHOUT battery
pack
-20-70°C
Weight 5.2 kg
Measured sound power level L
WA
98 dB(A)
K=2.3 dB(A)
Sound pressure level at operator’s
ear L
PA
90 dB(A)
K=2.5 dB(A)
Guaranteed sound power level L
WA
(measured according to 2000/14/EC)
100 dB(A)
Valuation of
vibration a
h
:
Front-assist handle
4.4 m/s
2
K=1.5 m/s
2
Rear handle
3.9 m/s
2
K=1.5 m/s
2
◾ The above parameters are tested and measured
equipped with power head PH1400E.
◾ The declared vibration total value has been measured
in accordance with a standard test method and may be
used for comparing one tool with another;
◾ The declared vibration total value may also be used in a
preliminary assessment of exposure.
NOTICE: The vibration emission during actual use of the
power tool can differ from the declared value in which the
tool is used; In order to protect the operator, user should wear
gloves and ear protectors in the actual conditions of use.
PACKING LIST(FIG. A)
DESCRIPTION
KNOW YOUR SNOW SHOVEL ATTACHMENT (Fig. A)
1. Deflector Adjust Knob
2. Shaft
3. Sealing Screw
4. Deck
5. Deflector
6. Scraper Bar
7. Auger
8. Auger Shaft
9. Hex Wrench
10. End Cap
ASSEMBLY
WARNING: If any parts are damaged or missing, do
not operate this product until the parts are replaced. Use of
this product with damaged or missing parts could result in
serious personal injury.
WARNING: Do not attempt to modify this product
or create accessories not recommended for use with this
product. Any such alteration or modification is misuse and
could result in a hazardous condition leading to possible
serious personal injury.
UNPACKING
◾ Inspect the tool carefully to make sure that no
breakage or damage occurred during shipping.
◾ Do not discard the packing material until you have
carefully inspected and satisfactorily operated the tool.
CONNECTING THE SNOW SHOVEL ATTACHMENT TO
THE POWER HEAD
This snow shovel attachment is designed for the use with
EGO Power Head PH1400E.
See “INSTALLING AN ATTACHMENT TO THE POWER
HEAD” section in the power head PH1400E operator’s
manual.
REMOVING THE ATTACHMENT FROM THE POWER
HEAD
See “REMOVING THE ATTACHMENT FROM THE POWER
HEAD” section in the power head PH1400E operator’s
manual.
OPERATION
WARNING: Do not allow familiarity with this product
to make you careless. Remember that a careless fraction of
a second is sufficient to inflict serious injury.
To Next Page
Loading...
