Quick Set-up Guide
EGO-360 i7w Speaker with
MicroSD Card *Read/Write
360º Omni-Directional Sound
Please read your manual carefully to familarise yourself with your EGO-360 i7w prior to
setup & initial operation.
How to charge your EGO-360 i7w speaker
Before using your EGO-360 i7w speaker
PRECAUTIONS
1. Care should be taken to avoid placing your EGO-360 i7w in the following locations:
(a) Near heat sources or direct sunlight
(b) Wet or humid locations
2. EGO-360 i7w is not waterproof. Do not allow water to enter your EGO-360 i7w.
Caring for your EGO-360 i7w
3. To clean the black Viscous Gel-Pad, use a clean, lint-free damp cloth to remove excessive
build up of dirt or dust.
4. Only place your EGO-360 i7w Vibration Speaker on flat surfaces.
5. Only use our dedicated glass Suction Cup (accessory) for vertical windows/glass & utilise the
Gel-Pad Protection Disc (9). Apply slight moisture to suction-cup surface & engage the
‘Swivel-Lock’.
6. Our Hard-Surface Mount (accessory) is for materials of non-glass both vertical & above.
Handy Tips
7. For best result, select surfaces that resonate well (i.e. pine, melamine, polystyrene, cardboard,
plastic, domestic glass).
8. Your EGO-360 i7w will not work well on concrete, laminated glass, stone bench tops, or other
thick/solid objects or extremely soft objects like material or skin.
WARNING
Never use with a damaged or defective power supply cord.
To reduce the risk of electric shock, do not attempt to open the casing of your EGO-360 i7w speaker.
Please visit our website for a full instruction manual,
accessories, spare parts, FAQ’s, support & more:
www.ego-360.com
Designed in Australia & Manufactured in China
ROHS
CONGRATULATIONS
on the purchase of your EGO-360 i7w Intelligent Speaker!
1. Remove the white plastic Gel-Pad Protection Disc (9) to expose the black Viscous Gel-Pad (8)
before use.
2. Your EGO-360 i7w speaker will work on any flat, clean, solid and smooth surface e.g. table
(glass or wood), cardboard, plastic, window (with optional glass suction cup).
3. Lightly press the top of your EGO-360 i7w to create a good connection between the
Gel-Pad and the surface used.
Note:
Please ensure to remove the MicroSD card when charging from a non-Plug & Play device
(i.e. AC USB charger, car USB charger etc.)
1. Insert the Mini-USB Connector from the Data/Charge Cable (11) into the Mini-USB Port (5)
located on the side of your EGO-360 i7w.
2. Plug the Type A USB connector on the other end into an external USB power source (i.e. phone
charger, PC/Laptop, car charger).
3. The LED Indicator Light (2) will glow red when charging from a power source and turn bright
green when fully charged.
Charge Time = 1-2 hours Playback Time = 8-10 hours
(playback time may vary as to volume level used)
To Next Page
Need help?
General