EGO CTA9500 User Manual

CULTIVATOR ATTACHMENT — CTA9500/CTA9500-FC16
MOUNTING THE GUARD
WARNING:
Install the guard before
the cultivator attachment is connected to
the power head.
1. Loosen and remove the bolt from
the guard with the supplied hex
wrench (Fig. 2).
2. Lift the cultivator attachment shaft
and remove the end cap from the
shaft.
3. With the slot in the guard aligned
with the rib on the end of the shaft,
pass the guard through the shaft
until the screw holes in the guard
and in the shaft are aligned
(Fig. 3 & 4).
4. Use the supplied hex wrench to
tighten the bolt clockwise to lock
the guard securely.
2
4
Bolt
3
Rib
Slot

EGO CTA9500 Specifications

General

Brand	EGO
Model	CTA9500
Category	Tiller
Language	English