EGO PSA1000 User Manual

POLE SAW ATTACHMENT — PSA1000 25
7. Lift the tip of the guide bar to check
for sag (Fig. 15). Release the tip of
the guide bar and turn the chain-
tensioning screw once clockwise.
Repeat this process until the sag is
eliminated.
8. Hold the tip of the guide bar up
and tighten the chain-sprocket-
cover screw securely. The chain is
correctly tensioned when there is no
sag on the underside of the guide bar and the chain is snug, but it can be turned
by hand without binding.
NOTICE: If the chain is too tight, it will not rotate. Loosen the chain-sprocket-cover
screw slightly and turn the tensioning screw 1/4 turn counterclockwise. Lift the tip of
the guide bar and retighten the chain-sprocket-cover screw securely. Assure that the
chain will rotate without binding.
15
Lift the Tip of the Guide
Bar Up to Check for Sag

EGO PSA1000 Specifications

General

Brand	EGO
Model	PSA1000
Category	Pole Saw
Language	English