EGO PSA1000 User Manual

POLE SAW ATTACHMENT — PSA100034
PROBLEM CAUSE SOLUTION
Pole saw does
not cut properly.

Insufcient chain tension.

Remove the battery pack and readjust
the chain tension, following the
section “ADJUSTING THE CHAIN
TENSION”.

Dull chain.

Sharpen the chain cutters, following
the section “How to Sharpen the
Cutters”.

Chain installed backwards.

Remove the battery pack and reinstall
the saw chain, following the section
“REPLACING THE BAR AND CHAIN”.

Worn chain.

Remove the battery pack and replace
the chain following the section
“REPLACING THE BAR AND CHAIN”.

Dry or excessively stretched
chain.

Check the oil level. Rell the oil tank if
necessary.

Chain not in bar groove.

Remove the battery pack and reinstall
the saw chain, following the section
“REPLACING THE BAR AND CHAIN”.
Bar and chain
running hot and
smoking.

Check chain tension for over
tightened condition.

Remove the battery pack and
re-tension the saw chain; see the
section “ADJUSTING THE CHAIN
TENSION”.

Chain oil tank is empty.

Filling bar and chain lubricant.

Debris in guide bar groove.

Clear the debris in the groove.

EGO PSA1000 Specifications

General

Brand	EGO
Model	PSA1000
Category	Pole Saw
Language	English