EGO PSX2510 - Page 25

FILLING THE OIL TANK WITH BAR AND CHAIN LUBRICANT (Fig. 9)
WARNING:
Do not smoke or bring any fire or flame near the oil or the pole saw.
Oil may spill and cause a fire.
NOTICE: The pole saw is not filled with oil at the time of purchase. It is essential
to fill the tank with chain oil before use. Operating the pole saw without chain oil or
when the oil level is below the ‘MIN’ mark will result in damage to the pole saw. Chain
life and cutting capacity depend on optimum lubrication. The chain is automatically
lubricated with chain oil during operation, if there is sufficient oil in the reservoir. Oil
level should also be checked after every 20 minutes of use and refilled as needed.
1. Remove the battery pack from the
power head.
2. Clean the oil-tank cap and the area
around it to ensure that no dirt falls
into the oil tank.
3. Lay the pole saw on a firm, flat
surface, so that the oil tank cap is
facing upwards.
4. Lift the tab of the oil tank cap (Fig. 9a).
5. Use the tab to rotate the oil tank cap
counterclockwise to remove it.
6. Carefully pour the bar and chain oil
into the tank until it fills to the tank
neck. Be careful not to let the oil spill
from the opening. Wipe off any excess
oil.
7. Install the oil tank knob and rotate the
knob to tighten it (Fig. 9b).
8. Close the tab oil tank cap.
NOTICE:
◾
Use EGO authorized bar and chain lubricant (Model# AOL3200 or AOL1000) for best
results. It is specially designed to provide low friction and faster cuts.
2
1
3
9b
9a
Tab
Oil Tank Cap
56-VOLT LITHIUM-ION COMMERICAL POLE SAW — PSX2510/PSX2510-FC 25