REPLACING THE BAR AND SAW CHAIN
WARNING:
Always wear gloves when handling the bar and chain; these
components are sharp and may contain burrs.
WARNING:
Never touch or adjust the chain while the motor is running. The saw
chain is very sharp; always wear protective gloves when performing maintenance to
the chain.
When replacing the guide bar and chain, always use the specified bar and chain
combination listed in the “RECOMMENDED ACCESSORIES” section.
1. Remove the battery and allow the saw to cool. Make sure the oil-tank cap is tight to
prevent oil leakage.
2. Position the pole saw on its side on a firm, flat surface, so that the side cover is
facing upwards.
3. Wear gloves. Remove the side cover by turning the cover nut counterclockwise
using the multi-function wrench. Clean the side cover with a dry cloth.
4. Remove the worn bar and chain from the mounting surface.
5. Install new guide bar and saw chain, following the “ASSEMBLING THE GUIDE BAR
AND SAW CHAIN” instructions in “ASSEMBLY” section.
NOTICE: This is a good time to inspect the drive sprocket for excessive wear or
damage.
56-VOLT LITHIUM-ION COMMERICAL POLE SAW — PSX2510/PSX2510-FC32
To Next Page
Loading...
Need help?
General
