1 5
en
Application scope
This document applies to the EGO Smart Heater types
No. 29.6x335.0xx (RS485 interface) as well as
29.6x335.1xx (LAN interface) for communication with a
remote station.
Installation pointers
The EGO Smart Heater must only be installed by
specialist technicians with the follow ing qualifications:
- Authorized specialist for installation and
commissioning
- Training in electrical risks and customary safety
regulations
- Knowledge of applicable standards and guidelines for
installation
- Knowledge of and compliance with this document and
all safety instructions.
Intended use
The EGO Smart Heater is a screw-in heater contr olled by
a communication interface to heat up water and aqueous
solutions (e.g. hot water sto ra ge) .
The EGO Smart Heater is suitable to optimise the own
power consumption by converting electrical energy, for
example from the photovoltaic system, into thermal
energy.
The output of the EGO Smart Heater can be adjus ted
within the range 0W to 3500W in 500W steps.
To Next Page
Loading...
Need help?
General