To Next Page

To Previous Page

56V LITHIUM-ION CORDLESS SNOW BLOWER — SNT2100 19

WARNING:

The auger will continue to rotate for a few seconds after the snow

blower is turned off. Allow the auger to stop rotating before starting it again.

NOTICE: Do not rapidly turn the snow blower off and on.

To Start the Snow Blower

1. Ensure that the side rails are

securely locked in the unfolded,

open position.

2. Attach the battery pack(s) to the

snow blower and close the battery

cover.

NOTICE: Make sure that the latch on the

snow blower snaps into place and that the

battery pack(s) are secured to the snow

blower before operation.

3. Depress the safety button and, with

the button depressed, pull the bail

switch upward to meet the handle

(Fig. 13 &14).

4. Once the tool powers on, release the

safety button and begin operation

(Fig. 15).

NOTICE: The tool is started by

depressing the safety button rst,

followed by squeezing the bail switch; the

reverse operation will not start the tool.

NOTICE: The snow blower may not

properly start if its battery temperature

is -4°F (-20°C) or less. If unit doesn’t

start, remove the battery from the snow

blower and allow it to warm indoors for

10 minutes or longer. Reinstall the battery and try again.

EGO SNT2100 User Manual

Questions and Answers: