A Definition
a
Float
b
Float chamber with cable clip
c
Filter car-
tridge
d
Pump cover with power regulator
e
3 x suc-
tion units
f
Pump wheel
g
Motorbody.
Pull out the power cord. Remove the float. Tilt the float
chamber upwards by applying gentle pressure
A
and re-
B Installation and operation
Press the 3 suction units
e
into the lateral openings of
the pump cover
d
with a rotating movement. Insert the
power cord into the cable guide
b
and secure the micro
surface skimmer to the inside wall of the aquarium below
the water level. The float
a
may not protrude more than
3 cm from the float chamber.
TIP: Place the micro surface skimmer so that the float pro-
trudes as far as possible from the float chamber (max.
3 cm), with the aquarium filled to the maximum. Thus,
sinking of water level through evaporation can be opti-
mally compensated.
TIP: To prevent the introduction of air bubbles, the power
regulator
d
should be set at a minimum level during the
initial installation or use of a new filter cartridge. As the
water becomes dirtier, the power regulator can then be gra-
dually increased to maximum level.
Following installation, put the micro surface skimmer into
operation by plugging in the power cord.
C Care and maintenance
Do not clean the unit – or parts of it – in the dish-
water. Not dishwater resistant!
Do not dispose of this product as normal house-
hold waste. Take it to your local refuse collection
side.
The product is qualified in
accordance with the respec-
tive national regulations and guidelines and meets
EC standards.
To Next Page
Loading...
