EHOB WAFFLE Cushion User Manual

Continued on other side •
Using the WAFFLE® L.A.D. Pump, insert the tip
of the pump into the valve. Refer to the inflation
chart on the side of the pump, and inflate your
cushion using the recommended level of strokes.
Set-Up
Once the cushion appears about 60% full, check
for proper inflation. If you can easily roll one side
of the product past the first set of holes, but not
to the second, your cushion is ready to use.
Place product on seating surface, valve down
and towards the back of the surface.
Cushion
Step 1: Inflate Step 2: Check Step 3: Utilize
Indications for Use
• Prevention and management of pressure injuries
• Patient comfort
• Use across the continuum of care
Precautions
• If used in a chair, position shifts should be made
every 15–30 minutes or per individualized schedule
• Avoid direct contact between skin and product
by using a pillowcase, sheet, or breathable under-pad
• Single patient use
• Weight Limit: 300 lbs.

EHOB WAFFLE Cushion Specifications

General

Brand	EHOB
Model	WAFFLE Cushion
Category	Medical Equipment
Language	English

Summary

Indications for Use

Precautions

Set-Up

Inflate

Insert the pump tip into the valve and inflate cushion using the recommended level of strokes.

Check

Verify proper inflation by rolling one side past the first set of holes, but not the second.

Utilize

Place product on seating surface with valve down and towards the back.

Additional Uses for Protection

Behind Head

Illustrates using the cushion behind the head for support or pressure relief.

Under Elbow

Demonstrates placement under the elbow for pressure relief and support.

Between Knees

Shows how to position the cushion between the knees for comfort and alignment.

Additional Support

Depicts using the cushion for general additional support in various positions.

Cleaning Instructions